Rodgers Instruments W-5000 Uživatelská příručka stáhnout pdf (Strana 118)

Chapter 10

118

Phase: 0-120

This parameter allows you to adjust the phase angle of the effect. Press the [NEXT] button to select this

parameter. Use the [+] and [-] (or [++]/[--]) buttons to set the phase angle.

[DRAWBAR DISTORT] Parameters

These parameters affect the Drawbar distortion sound. Press the [DRAWBAR DISTORT] button in the

EFFECTS section to access these parameters:

Drawbar Distort

Input Gain: -50-50

This parameter allows you to set the input gain which determines the amount of distortion that will be heard.

Use the [+]/[-] buttons to set the gain level. (This parameter is variable to allow the input signal to reach the

threshold (see the following).)

Ret Level: 0-127

This parameter allows you to set the return level; the volume of the distortion sound. Press [NEXT] to select

this parameter. Use the [+]/[-] buttons to set the level.

(Note: The Threshold, Flatten and Peaking parameters represent very technical aspects of sound

manipulation. Rather than trying to explain the technicalities of what is happening, we urge you to

experiment - your ears will tell you when you've got the sound you want!)

Threshold P: -10-10

This parameter allows you to set the positive (P) threshold point; the point at which the following parameters

will take effect. Press [NEXT] to select this parameter. Use the [+]/[-] buttons to set the positive threshold;

lower numbers mean the Flatten and Peaking parameters will have a greater affect; signals below this

threshold are unaffected.

Threshold N: -10-10

This parameter allows you to set the negative (N) threshold point; the point at which the following

parameters will take effect. Press [NEXT] to select this parameter. Use the [+]/[-] buttons to set the negative

threshold; higher numbers mean the Flatten and Peaking parameters will have a greater affect; signals above

this threshold are unaffected.

Flatten P: -50-50

This parameter allows you to control the positive (P) rounding shape of the waveform above Threshold P.

Press [NEXT] to select this parameter. Use the [+]/[-] buttons to shape the waveform.

Flatten N: -50-50

This parameter allows you to control the negative (N) rounding shape of the waveform below Threshold N.

Press [NEXT] to select this parameter. Use the [+]/[-] buttons to shape the waveform.

Peaking P: -50-50

This parameter allows you to adjust the positive (P) peaking shape of the waveform above Threshold P.

Press [NEXT] to select this parameter. Use the [+]/[-] buttons to adjust the positive peak signal.

Peaking N: -50-50

This parameter allows you to adjust the negative (N) peaking shape of the waveform below Threshold N.

Press [NEXT] to select this parameter. Use the [+]/[-] buttons to adjust the negative peak signal.

[DRAWBAR CLICK] Parameter

This button turns the Drawbar Click effect on and off and also allows you to access the Click Filter

parameter. Use the [+]/[-] (or [++]/[--]) buttons to set the 'Click Flt' level (0-127); the brightness of the click

noise heard. Additional Drawbar Click parameters can be accessed by pressing the [CURRENT

DRAWBAR] button or any of the [DRAWBAR PRESET] buttons ([A], [B] or [C]).

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 164 165

Komentáře k této Příručce

Žádné komentáře

Rodgers Instruments W-5000 Uživatelská příručka Strana 118

Komentáře k této Příručce

Související produkty a manuály pro Hudební nástroje Rodgers Instruments W-5000